3D Printing – Toto's Garage https://totosgarage.com/en/ make it in da garage Tue, 16 Jul 2024 07:50:07 +0000 en-US hourly 1 https://wordpress.org/?v=7.1.2 https://totosgarage.com/cms/wp-content/uploads/2021/03/cropped-logo-1024-150x150.png 3D Printing – Toto's Garage https://totosgarage.com/en/ 32 32 What to do if the build plate does not adhere https://totosgarage.com/en/what-to-do-if-the-build-plate-does-not-adhere/ Tue, 16 Jul 2024 07:50:07 +0000 https://totosgarage.com/what-to-do-if-the-build-plate-does-not-adhere/ I am printing with a Creality Ender 3 V3 KE.

I encountered an issue where the model would not adhere to the build plate. The filament is PLA.

I dealt with the issue in the following order:

1. Make the X-axis parallel to the Z-axis

2. Adjust the Z-axis. It is within approximately 0.20 mm.

3. Adjust the filament and build plate.

I set the build plate temperature to 210 degrees and 70 degrees, respectively, which are higher.

4. Set the brim.

5. Slow down the Initial Printing Speed. I set it to 1/4 of the initial value.

6. Increase the height and width of the Initial Layer.

With these adjustments, I am now able to print without any problems.

]]>