What to do if the build plate does not adhere
I am printing with a Creality Ender 3 V3 KE. I encountered an issue where the model would not adhere to the build plate. The filament is PLA. I dealt with the issue in the following order: 1. Make the X-axis parallel to the Z-axis 2. Adjust the Z-axis. It is within approximately 0.20 mm. 3. Adjust the filament and build plate. I set the build plate temperature to 210 degrees and 70 degrees, respectively, which are higher. 4. Set the brim. 5. Slow down the Initial Printing Speed. I set it to 1/4 of the initial value. 6. Increase the height and width of the Initial Layer. With these […]